Spark Plug Interchange Tables will be found in the general section under the heading:Ignition-Distributor-Tune-up. Because of this be sure to ground the primary ignition circuit before using the starter to turn the engine when working under the hood otherwise the engine may fire. ![]() A contact finger in the starter solenoid by-passes the resistor when the starter is turning the engine. On all V-8 models there is an ignition ballast resistor connected between the ignition switch and the coil. When timed according to specs reconnect vacuum unit and reset idle speed to specs. You have just purchased an overlock sewing machine for sewing all kinds of fabricscotton, wool, rayon, tricot, jersey, knitted goodsthick or thin. ![]() Thank you very much for purchasing an Overlock sewing machine. Disconnect and plug vacuum advance line at Vacuum unit. HANDBOOK FOR OVERLOCK SEWING MACHINE MODELS 530/530D and 5461546D :Ef cx: CC c. The indicator plate on the chain cover has '0' at top dead center and 3 marks at 2 1/2 degree intervals before TDC (2 1/2,5,7 1/2 degrees before top dead center). 1950-53, All Yellow mark on flywheel one degree wide at the correct point.ฤก954-59, All V-8: Yellow mark on crankshaft pulley.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |